![background image](http://html.mh-extra.com/html/ryobi/ry43200/ry43200_operators-manual_1505967019.webp)
Page 19 — English
CHAIN OILER
See Figure 18.
Use Premium Bar and Chain Lubricant. It is de-
signed for chains and chain oilers and is formu-
lated to perform over a wide temperature range
with no dilution required.
Stop the motor and disconnect from power
supply.
Remove the oil reservoir cap and carefully pour
approximately 2 oz. of bar and chain lubricant
into the tank.
Replace the cap and tighten securely.
Check and refill the tank every time the lopper
is used.
NOTE:
Do not use dirty, used, or otherwise con-
taminated lubricants. Damage may occur to the
oil pump, bar, or chain.
CHAIN MAINTENANCE
See Figure 19 - 20.
Use only low-kickback chain on this saw. This
fast-cutting chain will provide kickback reduction
when properly maintained.
For smooth and fast cutting, chain needs to be
maintained properly. The chain requires sharpen-
ing when the wood chips are small and powdery,
the chain must be forced through the wood dur-
ing cutting, or the chain cuts to one side. During
maintenance of your chain, consider the following:
Improper filing angle of the side plate can in-
crease the risk of a severe kickback.
Raker (depth gauge) clearance.
Too low increases the potential for kickback.
Not low enough decreases cutting ability.
If cutter teeth have hit hard objects such as nails
and stones, or have been abraded by mud or sand
on the wood, have service dealer sharpen chain.
NOTE:
Inspect the drive sprocket for wear or dam-
age when replacing the chain. If signs of wear or
damage are present in the areas indicated, have the
drive sprocket replaced by a Ryobi service dealer.
MAINTENANCE
Fig. 18
Fig. 19
RAKER (DEPTH GAUGE)
CLEARANCE
.025 in.
CUTTING
CORNER
SIDE PLATE
DEPTH GAUGE
TOE
GULLET
HEEL
RIVET HOLE
TOP
PLATE
PARTS OF A CUTTER
Fig. 20
OIL
RESERVOIR
CAP
QUICK VIEW
OIL INDICATOR
Содержание RY43200
Страница 45: ...Page 24 Français NOTES ...
Страница 67: ...Página 24 Español NOTAS ...