![background image](http://html.mh-extra.com/html/ryobi/ry43200/ry43200_operators-manual_1505967016.webp)
Page 16 — English
WARNING:
When servicing, use only identical replacement
parts. Use of any other parts could create a
hazard or cause product damage.
WARNING:
Always wear eye protection with side shields
marked to comply with ANSI Z87.1, along with
head protection. Failure to do so could result in
objects being thrown into your eyes and other
possible serious injuries.
WARNING:
Before inspecting, cleaning or servicing the unit,
stop the motor, wait for all moving parts to stop,
and disconnect from power supply. Failure to
follow these instructions can result in serious
personal injury or property damage.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts.
Most plastics are susceptible to damage from
various types of commercial solvents and may be
damaged by their use. Use clean cloths to remove
dirt, dust, oil, grease, etc.
WARNING:
Do not at any time let brake fluids, gasoline,
petroleum-based products, penetrating oils, etc.,
come in contact with plastic parts. Chemicals can
damage, weaken, or destroy plastic, which could
result in serious personal injury.
Only the parts shown on the parts list are intended
to be repaired or replaced by the customer. All
other parts should be replaced at an Authorized
Service Center.
CHAIN TENSION
See Figures 11 - 13.
WARNING:
To avoid possible serious injury, never touch or
adjust the chain while the motor is running. The
saw chain is very sharp; always wear protec-
tive gloves when performing maintenance to
the chain.
Stop the motor and disconnect from power
supply.
Pull the front handle all the way back and de-
press the lower jaw lock button. Keep the button
depressed while releasing the handle to lock the
lower jaw in the open position.
Loosen the chain cover bolt to finger tight using
the combination wrench provided, then turn the
chain tensioning screw clockwise to tension the
chain. Refer to
Replacing the Bar and Chain
for additional information.
NOTE:
A cold chain is correctly tensioned when
there is no slack on the underside of the guide
bar, the chain is snug, but it can be turned by
hand without binding.
MAINTENANCE
Fig. 11
FRONT
HANDLE
LOWER
JAW LOCK
BUTTON
CHAIN
COVER
BOLT
CHAIN
TENSIONING
SCREW
LOWER
JAW
Содержание RY43200
Страница 45: ...Page 24 Français NOTES ...
Страница 67: ...Página 24 Español NOTAS ...