9 — English
TURNING THE SPRAYER ON/OFF
See Figures 8 - 9.
Turn the control knob clockwise to turn the sprayer ON
and to adjust fluid pressure.
Turn the control knob clockwise to increase the pressure
and counterclockwise to decrease the pressure.
NOTE:
To apply more spray to an area, increase the
pressure. To apply less spray, decrease the pressure.
To start the flow of liquid at the spray wand, squeeze the
trigger.
To stop the flow of liquid at the spray wand, release the
trigger.
Turn the control knob completely counterclockwise to
turn the sprayer OFF.
LOCK-ON
See Figure 9.
The lock-on feature is convenient when spraying for an ex-
tended period of time or when covering a large area.
To lock-on, squeeze the trigger and slide the locking tab
backward.
To release the lock-on, squeeze the trigger and slide the
locking tab forward.
NOTE:
Make sure the trigger is not locked on before
inserting the battery pack into the sprayer.
ADJUSTING THE CONE SPRAY NOZZLE
See Figure 10.
The adjustable cone spray nozzle can be adjusted from a
stream to a cone spray.
Remove the battery pack from the tool.
Loosen the nozzle for a stream.
Tighten the nozzle for a cone spray.
USING THE SPRAYER
See Figure 11.
WARNING:
Improper application of cleaning solution can result in SE-
VERE INJURY or DEATH. Follow CDC and EPA guidelines
for cleaning. Follow the chemical manufacturer’s safety
instructions and guidelines listed on the SDS sheet and/
or EPA Master Label.
WARNING:
Risk of fire or explosion. Spray area must be well-
ventilated and away from sparks or flames.
Install the battery pack into the tool.
Turn the control knob clockwise to turn the sprayer ON.
Set desired pressure.
Slip arm through harness strap and onto shoulder, then
repeat for the other shoulder. Adjust the straps to a
comfortable position.
Direct the sprayer nozzle directly at the surface areas you
wish to treat.
NOTE:
Make sure to stand far enough from the object
being sprayed to prevent the spray from splashing back
onto you.
Squeeze and hold the switch trigger while the unit primes.
This may take several seconds. Continue holding the
trigger until unit begins to spray.
Spray on a dry surface using long, even, overlapping
strokes.
NOTE:
While the sprayer is in use some dripping from
the nozzle may occur, this is to be expected.
Release the trigger to stop the spray.
Allow surfaces to air dry. Follow chemical manufacturer’s
instructions regarding post-application cleaning of
surfaces, including rinse instructions for food contact
surfaces.
Always refer to the chemical bottle instructions, SDS
sheet and/or EPA Master label for proper dwell time of
chemicals.
When you are finished with the sprayer, take off the
shoulder harness.
Turn off the sprayer and remove the battery pack.
Unscrew the cap and remove it from the tank.
Return any unused fluid to its original container, and
thoroughly clean the sprayer.
Review chemical SDS sheet how best to secure and store
your chemical solution when not in use.
Thoroughly clean the sprayer and tank before transporting
or storing the unit and before switching to a different
chemical. See
Cleaning the Unit
later in this manual.
NOTE:
Wipe the outside of the tank with a dry cloth and
clean up any spills before inserting the tank.
WARNING:
Always flush unit when you change cleaning products.
Do not mix or combine chemicals.
Thoroughly wash your hands and any area where skin
has been exposed to the spray.
OPERATION
