3
English
|
EN
FR
DE
ES
IT
NL
PT
DA
SV
FI
NO
RU
PL
CS
HU
RO
LV
LT
ET
HR
SL
SK
BG
UK
TR
properly.
■
Never charge a damaged battery
pack. Replace damaged battery
packs immediately.
■
Before every use, examine the
supply cord for damage. If there are
signs of damage, it must be replaced
by a qualified person at an authorised
service centre to avoid a hazard.
ADDITIONAL BATTERY SAFETY
WARNINGS
WARNING
To reduce the risk of
fi
re, personal
injury, and product damage due to
a short circuit, never immerse your
tool, battery pack or charger in
fl
uid
or allow a
fl
uid to
fl
ow inside them.
Corrosive or conductive
fl
uids,
such as seawater, certain industrial
chemicals, and bleach or bleach-
containing products, etc., can cause
a short circuit.
ENVIRONMENTAL PROTECTION
Recycle raw materials
instead of disposing of
as waste. The machine,
accessories and packaging
should be stored for
environmentally friendly
recycling.
OPERATION
CHARGING THE BATTERY PACK
Battery packs are shipped in a low
charge condition. Therefore, you
should charge them before
fi
rst use. If
the charger does not charge the battery
pack under normal circumstances,
bring both the battery pack and charger
to an authorised service centre.
Make sure that the power supply is
normal household voltage, 220–240V,
50/60Hz, AC only.
Make sure that the battery pack latch
clicks into place and that the battery
pack is secured in the charger before
charging.
NOTE:
When the battery becomes fully
charged, the green LED remains on. It
is normal for the battery pack to become
slightly warm to touch while charging.
Do not place the charger and battery
pack in an area of extreme heat or
cold. They work best at normal room
temperature.
NOTE:
When charging, the charger
and battery pack should be placed in a
location where the temperature is more
than 10°C but less than 25°C.
CHARGING A COOL BATTERY PACK
See Fig. 2
1. Align the raised rib on the battery
pack with the groove in the product,
and slide in the battery pack. Make
sure that the battery pack latch clicks
into place.
2. Connect the product to a power
supply.
See Fig.3
1. Disconnect the product from the
power supply when the battery pack
becomes fully charged.
2. Press the battery pack latch to unlock
the battery pack from the product.
3. Slide the battery pack off the product.
CHARGING A HOT BATTERY PACK
When using a tool continuously, the
cells in the battery pack become hot. A
hot battery pack should be allowed to
cool down for approximately 30 minutes
Содержание RY36C60A
Страница 11: ...1 2 3 4 Fig 1 1 2 Fig 2 1 2 3 Fig 3 1 ...
Страница 18: ...8 English Full On Fast charging is complete charger maintains charge mode ...
Страница 206: ......
Страница 208: ...Techtronic Industries GmbH Max Eyth Straße 10 71364 Winnenden Germany 960324019 01 ...