![background image](http://html1.mh-extra.com/html/ryobi/pcl801/pcl801_operators-manual_1504910003.webp)
3 - English
WARNING:
Air Quality Hazard:
Do not use this heater for heating human living quar-
ters.
Use of direct-fired heaters in the construction envi-
ronment can result in exposure to levels of CO, CO
2
,
and NO
2
, considered to be hazardous to health and
potentially life threatening.
Do not use in unventilated areas.
Know the signs of CO and CO
2
poisoning.
• Headaches, stinging eyes;
• Dizziness, disorientation;
• Difficulty breathing, feels of being suffocated.
Proper ventilation air exchange (OSHA 29 CFR
1926.57) to support combustion and maintain accept-
able air quality shall be provided in accordance with
OSHA 29 CFR Part 1926.154, ANSI A10.10 Safety
Requirements for Temporary and Portable Space
Heating Devices and Equipment used in the Con-
struction Industry or the Natural Gas and Propane
Installation Codes CSA B149.1.
Periodically monitor levels of CO, CO
2
, and NO
2
exist-
ing at the construction site – at the minimum at the
start of the shift and after 4 hours.
Provide ventilation air exchange, either natural or
mechanical, as required to maintain acceptable
indoor air quality.
WARNING:
Adequate ventilation must be provided. A minimum 2
ft. sq. (0.19 m2) ventilation opening near floor and 2 ft.
sq. (0.19 m2) ventilation opening near ceiling must be in
place during use of this heater. Do not sleep while heater
is operating.
WARNING:
Read and save these instructions.
Failure to follow all
instructions listed below, may result in electric shock, fire
and/or serious personal injury.
SAVE THESE INSTRUCTIONS
When using propane:
This propane product must be installed in accordance with
the latest local codes. In the absence of local codes, use
the:
• United States:
— National Fuel Gas Code, ANSI Z223.1/NFPA 54
— LP Gas Code, NFPA 58
• Canada:
— Natural Gas and Propane Installation Code, CSA
B149.1
— Propane Storage and Handling Code, CSA B149.2.
Proper ventilation air exchange
(OSHA 29 CFR 1926.57)
to support combustion and maintain acceptable air qual-
ity shall be provided in accordance with
OSHA 29 CFR
Part 1926.154
,
ANSI A10.10 Safety Requirements for
Temporary and Portable Space Heating Devices and
Equipment
used in the Construction Industry or the Natural
Gas and Propane Installation Codes CSA B149.1.
Periodically monitor levels of CO, CO
2
, and existing NO
2
existing at the construction site – at the minimum at the
start of the shift and after 4 hours.
Provide ventilation air exchange, either natural or mechani-
cal, as required to maintain acceptable indoor air quality.
Always turn off gas at the propane cylinder (liquid propane
also called liquid petroleum gas) when the product is not
in use. Disconnect the cylinder before storage.
Before storing, allow the product to cool for 30 minutes
and remove propane cylinder from the unit. Do not store
a propane cylinder attached to or near the product. If not
followed exactly, a fire causing death or serious injury may
occur.
Inspect the hose for damage before each use. If it is
evident there is excessive abrasion or wear, or the hose
is cut, it must be replaced prior to the product being put
into operation. The replacement hose assembly shall be
that specified by the manufacturer. Use only replacement
hose part no. TYQ-5B1-QG005.
This heater must be located on stable and level surface
and located away from combustible surfaces by no less
than 24 inches from rear and sides of heater and 72 inches
from above and front outlet of heater.
Never fill the propane cylinder beyond 80 percent full. An
overfilled or improperly stored cylinder is a hazard due to
possible gas release from the safety release valve. If not
followed exactly, a fire causing death or serious injury may
occur.
Only use a propane cylinder that includes a collar to protect
the cylinder valve.
If a leak is detected at any time, get away from the propane
cylinder and call the fire department.
Do not use the product until leak-tested.
Propane cylinders must be stored outdoors out of reach
of children and must not be stored in a building, garage,
or any other closed in area.
Do not operate in altitudes above 2,000 ft.
WORK AREA
Keep your work area clean and well lit.
Cluttered benches
and dark areas invite accidents.
Do not operate propane heaters in explosive atmo-
spheres, such as in the presence of flammable liquids,
gases, or dust.
Propane heaters create sparks which may
ignite the dust or fumes.
IMPORTANT SAFETY INSTRUCTIONS
Содержание PCL801
Страница 35: ...NOTES NOTAS...