Ryobi EDP-5530L, Руководство пользователя

Страница: 31 / 228

23
GB
F D E
English
I P NL S DK N FIN GR H CZ RUS RO PL
ADJUSTMENTS
WARNING
Before performing any adjustment, make sure
the tool is unplugged from the power supply.
Failure to heed this warning could result in
serious personal injury.
ADJUSTING TABLE HEIGHT (Fig. 21)
■
Hold the table with one hand and loosen the table
lock handle (25).
■
Rotate the table adjustment handle (5) clockwise to
raise the table.
■
Rotate the table adjustment handle (5) counter-
clockwise to lower the table.
■
Position the table to the desired height and retighten
the table lock handle.
ADJUSTING TABLE BEVEL (Fig. 22)
The drill press is equipped with a tilting table that allows
you to drill angled holes. The table can be tilted left or
right, from 0° to 45°. To tilt the table:
■
Loosen the large hex bolt (o) located underneath the
table (Fig. 22).
■
Use the bevel scale (n) to tilt the table to the desired
angle (Fig. 21).
■
Retighten the hex bolt (o) securely.
ADJUSTING THE DRILLING DEPTH (Fig. 23)
To adjust the drilling depth when you need to drill a
number of holes to exactly the same depth:
■
Loosen the lock knob (4) (Fig. 23) and the spindle
lock lever (14) (Fig. 1).
■
Rotate depth gauge (3) to the desired setting (Fig. 23).
■
Retighten the lock knob securely.
MAINTENANCE
WARNING
When servicing, use only identical replacement
parts. Use of any other parts may create a
hazard or cause product damage.
WARNING
Always wear safety goggles or safety glasses
with side shields during power tool operation or
when blowing dust. If operation is dusty, also
wear a dust mask.
WARNING
To prevent accidental starting that could cause
possible serious personal injury, turn off the tool,
remove the switch key, and unplug the drill press
before performing any maintenance or
adjustment.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use.
Use clean cloths to remove dirt, dust, oil, grease, etc.
WARNING
Do not at any time let brake fluids, gasoline,
petroleum based products, penetrating oils, etc.,
come in contact with plastic parts. Chemicals can
damage, weaken or destroy plastic which may
result in serious personal injury.
■
After using the drill press, clean it completely and
lubricate all sliding and moving parts. Apply a light
coat of automotivetype paste wax to the table and
column to help keep the surfaces clean.
OPERATION
RECOMMENDED SPEED FOR DRILL SIZE & MATERIAL
SPEED RANGE (min -1 ) WOOD ALUM / ZINK / BRASS IRON / STEEL
in. mm in. mm in. mm
2150-3000 3/8 9.5 7/32 5.6 3/32 2.4
1600-2000 5/8 16.0 11/32 8.7 5/32 4.0
1250-1400 7/8 22.0 15/32 12.0 1/4 6.4
600-700 1-1/4 31.75 11/16 17.5 3/8 9.5
500-520 1-5/8 41.0 3/4 19.0 5/8 16.0
EDP-5530L-17 lgs 21/05/07 14:02 Page 23