Rydeen BSS-ONE, Руководство пользователя

Страница: 11 / 20

Installation
9
Step 2
Step 3
Using the allen key (large) provided. Adjust the angle of
sensor to -8 degree as shown right in the diagram.
Remove the bumper cover and clean the inside of the cover
where the sensor is to be placed. The area should be cleaned
with alcohol so that the adhesive pad on the sensor assembly
may be securely attached. Make sure the attaching surface is
smooth, so the adhesive can contact the surface well. If the
surface is rough, use sanding paper to make the surface
smooth. Clean and remove sanding particles. Affix the sensor
to the bumper cover taking note of the direction, orientation,
and designated location.
*** PRIMER MUST BE USED***
Step 4
Connect the radar sensor to the harness. Route the harness
assembly from the rear exterior of the vehicle into the cabin
utilizing a grommet. Secure the harness away from
any heat
sources and moving parts. Pass the harness through the
grommet ensuring the harness and connector do not become
damaged. Route the harness to the desired location and affix it
to the vehicle using cable ties.
Step 5
Instructions for A. indicator, B. buzzer.
A. Select locations for the right & left indicators to be installed (lower part of A pillars
are recommended for the best visibility), check for clearance
behind the panel. Mark the locations to be drilled with the provided tool. Drill holes.
Snap into place.
B. Locate a suitable buzzer installation location for the best audible effect. Affix the
buzzer using the adhesive patch or wire ties.