3 SET-UP
8
3
SET-UP
3.1 SET-UP __________________________________________________________________
Loose parts kit includes additional tines.
1.
Remove carton from unit.
2.
Lift seat assembly (lever located below seat on
right–front side, Figure 3A), cut ties from wooden
block located on hydraulic cylinder and remove
block.
Figure 3A
A.
Cover latch
3.
Insert three (3) tines per holder and tighten screws
securely.
BE SURE
tines are tight against shoulder
of tine holder.
4.
Attach tine holders to tine rams and secure with two
(2) flangelock nuts (See Figure 3B).
5.
Remove screw from beneath aerator lift pedal.
Figure 3B
A.
Flangelock Nut
B.
Tine Holder
C.
Tine
Note:
To prevent corrosion on gauge stem, replace fuel
tank cap with gauge cap after two (2) full tanks of fuel
have been run through the system.
On models shipped with a plastic bag over gauge stem,
fill fuel tank and remove bag before installing into fuel
tank.
WARNING
To prevent possible injury to yourself or others, stay
clear when cutting banding. Banding is under tension
and can snap back when cut.
DO NOT operate this equipment until you have read
the controls and operating sections thoroughly!
!
A
FRONT
OF
UNIT
C
A
B
Содержание 544915
