5 MAINTENANCE
14
5
MAINTENANCE
5.1 GENERAL ________________________________________________________________
1.
Adjustment and maintenance should always be
performed by a qualified technician. If proper
adjustments cannot be made, contact an Authorized
Jacobsen Dealer.
2.
Inspect the equipment on a regular basis, establish
a maintenance schedule and keep detailed records.
a.
Keep the equipment clean.
b.
Keep all moving parts properly adjusted and
lubricated.
c.
Replace worn or damaged parts before operating
the machine.
d.
Keep all fluids at their proper levels.
e.
Keep shields in place and all hardware securely
fastened.
f.
Keep tires properly inflated.
3.
Long hair, jewelry or loose fitting clothing may get
tangled in moving parts.
4.
Use the illustrations in the Parts Catalog as
reference for the disassembly and reassembly of
components.
5.
Recycle or dispose of all hazardous materials
(batteries, fuel, lubricants, anti-freeze, etc.)
according to local, state or federal regulations.
5.2
ENGINE _________________________________________________________________
Important: A separate Engine Manual, prepared by
the engine manufacturer, is supplied with this unit
.
Read the engine manual carefully until you are
familiar with the operation and maintenance of the
engine. Proper attention to the engine
manufacturer’s directions will assure maximum
service life of the engine. To order replacement
engine manuals contact the engine manufacturer.
The proper break-in of a new engine can make a
considerable difference to the performance and life of the
engine.
During the break-in period, Jacobsen recommends the
following:
1.
During the first 50 hours of operation, a new engine
should be allowed to reach an operating temperature
of at least 140°F (60°C) prior to operation at full load.
2.
Check the engine oil level twice daily during the first
50 hours of operation. Higher than normal oil
consumption is not uncommon during the initial
break-in period.
3.
Change engine oil and oil filter element after first 50
hours of operation.
4.
Refer to Section 7.3 and Engine Manual for specific
maintenance intervals.
5.3
ENGINE OIL ______________________________________________________________
Check the engine oil at the start of each day, before
starting the engine. If the oil level is low, remove oil filler
cap and add oil as required.
Perform initial oil change after first 50 hours of operation
and every 100 hours thereafter. See Engine Manual.
Use only engine oils with API classification SG, SH, or
SJ.
WARNING
Before you clean, adjust, or repair this equipment,
disengage all drives, lower implements to the ground,
stop engine and remove key from ignition switch to
prevent injuries
!
Содержание 544915
