ryan 544915, Руководство по запасным частям и обслуживанию

Страница: 28 / 102

7 MAINTENANCE & LUBRICATION CHARTS
28
7 MAINTENANCE & LUBRICATION CHARTS
7.1 GENERAL ________________________________________________________________
1. Always clean the grease fitting before and after
lubricating.
2. Lubricate with grease that meets or exceeds NLGI
Grade 2 LB specifications. Apply grease with a
manual grease gun and fill slowly until grease
begins to seep out. Do not use compressed air
guns.
3. Periodically apply a small amount of lithium based
grease to the seat runners.
4. For smooth operation of all levers, pivot points and
other friction points that are not shown on the
lubrication chart apply several drops of SAE 30 oil
every 40 hours or as required.
5. Grease fittings on Figure 7A, (A) daily, (G) annually,
(F) daily or every time unit is refueled, (D) after 200
hours and (E) weekly.
7.2 LUBRICATION CHART _____________________________________________________
Figure 7A
A. Lubrication Fittings (5)
B. Hydraulic Filter
C. Reversing Gearbox (2)
D. Hydraulic Reservoir
E. Vehicle Drive Chain
F. Aerator Drive Chains (2)
G. Steering Gearbox (for units with steering wheel)
WARNING
Before you clean, adjust, or repair this equipment,
disengage all drives, engage parking brake, stop
engine and remove key from ignition switch to
prevent injuries
!
A
A
A
A
B
C
D
E
F
G
A