Ruris AS130FULL, Руководство пользователя

Страница: 35 / 40

EN
15
5. Cut any section of deformed wire and prepare the tip so that it is
not sharp.
Note: You can use a file to remove the sharp tip of the wire.
6. Open the pressure arm of the mechanism and raise the upper
roller on its pivot.
7. Position the feed roller according to the wire used (0.8 / 1mm).
8.Pull the wire detached from the coil and push it carefully through the wire guide behind
the mechanism. Push the wire over the groove of the feed roller and through the wire
guide.
9. Place the upper feed roller over the wire and close the pressure arm.
10. Press the trigger of the welding gun and allow the wire to pass through the gun cable
to the contact tip.