Runco Vistage series, Руководство по эксплуатации

Страница: 67 / 94

Operation
Vistage™ Series Flat-Panel Display Installation/Operation Manual 53
PRE
L
IMINAR
Y
• CUE (Chroma Up s ampling Error) Correction: Some DVD players use MPEG
decoders that do not correctly “upsample” the 4:2:0 format chroma information on the
DVD to the 4:2:2 or 4:4:4 format required by the video encoder of the display device.
This so-called “chroma bug” sometimes causes streaky or spiky horizontal lines
running through the chroma channel. It is most noticeable in static, interlaced scenes
and on diagonal edges (especially red ones). Set CUE to
On to correct this issue.
• Remote Code: Select Remote Code from the Miscellaneous menu to set the infrared
(IR) code set to which the DHD Controller will respond. By default, it is set to 17. You
can change this setting if either:
• Another device in the theater (a DVD player, for example) is responding to
commands from the DHD Controller remote control (Figure 2-6) in ways that are
unpredictable or undesirable.
• You have multiple DHD Controllers and want to control them independently, as
opposed to broadcasting commands from a single remote to all of them. In this
scenario, you can use multiple remotes programmed to use different IR codes. Or,
you can use a single remote and change the IR code as needed to address a
specific DHD Controller.
When you change a remote code on the DHD Controller, you must re-program the
DHD Controller remote control to send that same code. To do this:
1. Press and hold the LIGHT button on the
remote control for approximately three
seconds, or until the LED on the remote lights
solid red.
2. Enter a new two-digit code between 00 and 31
inclusive. Include a leading zero for single-digit
codes; for example, enter 9 as “09.”
3. The LED turns off to confirm the code change. If you enter an invalid code, the LED
flashes for three or four seconds. Try again, entering a valid code.
Use the serial command
REMOTECODE [0 ... 31]
to change
the IR code to which the controller will respond (refer to
Miscellaneous Commands on page 63). Then, change the code
sent by the remote to match as described below.
Tip
ON OFF
LIGHT