Runco Reflection RS-440, Руководство пользователя

Страница: 66 / 84

Operation
52 Runco RS-440 Installation/Operation Manual
PRE
L
IMINAR
Y
Factory Re s et: To restore all Setup Menu options to their factory-default values, select
Factory Reset and press ENTER. Use the arrow buttons to highlight “OK,” then press
ENTER again to confirm the operation.
ISF To access the ISF calibration menu, select ISF from the Main Menu and press ENTER .
Picture Memory: Refer to Picture Memory on page 39.
Brightne ss : Refer to Brightness on page 40.
Contra s t: Refer to Contrast on page 40.
Color: Refer to Color on page 41.
Tint: Refer to Tint on page 42.
S harpne ss : Refer to Sharpness on page 42.
Gamma: Refer to Gamma on page 42.
Color Temp.: Refer to Color Temp. on page 42.
BrilliantColor™: Refer to BrilliantColor™ on page 43.
Black Level: Refer to Black Level on page 43.
White Balance: To remove any trace of color from the white areas of the projected
image, select White Balance from the ISF menu and press ENTER .
• Gain: Use the Gain controls to correct color imbalances in the bright areas of the
image. A good way to do this is to use a test pattern consisting mostly of solid white
areas, such as an 80 IRE “window” pattern. If the white areas contain traces of red,
green or blue, decrease the Gain for that color.
• Off s et: Use the Offset controls in the White Balance sub-menu to correct color
imbalances in the dark areas of the image. A good way to do this is to use a test
pattern consisting mostly of dark gray areas, such as a 30 IRE “window” pattern. If the
gray areas contain traces of red, green or blue, decrease the Offset for that color.
The Gain controls increase or decrease the full-scale input range; the Offset controls
shift the entire range, resulting in a change in brightness.
DNR: Refer to Digital Noise Reduction (DNR) on page 51.
I S F
Picture Memory Cu s tom
Brightne ss 0
Contra s t 0
Color 0
Tint 0
S harpne ss 3
Gamma 2.2
Color Temp. 6500
BrilliantColor™ Off
Black Level 0 IRE
White Balance
DNR 0
S ave S etting s
Blue Image Off
S pla s h S creen Timer 5
Re s et to Default s
➤
This menu should be used by ISF-certified technicians only. You must
enter a passcode to access this menu.
Generally, higher Gain settings reduce the image contrast; higher
Offset settings reduce the image brightness.
Note
Note