Runco Reflection RS-440, Руководство пользователя

Страница: 57 / 84

Operation
Runco RS-440 Installation/Operation Manual 43
PRE
L
IMINAR
Y
Color S pace: Select Color Space from the Picture Adjust menu to choose the color
space of the source signal for HDMI, RGB and component connections.
• The default setting, Auto , functions as follows:
• HDMI/DVI-D: If the Auxiliary Video Information (AVI) infoframe contains color space
and/or range data, the RS-440 uses that information. Otherwise, for RGB sources,
the RS-440 uses the
RGB-Video color space. For component SDTV and EDTV
resolutions, S DTV is used. For other component video resolutions, HDTV is used.
• DVI-A: If Hsync or Vsync signals are present, the RS-440 uses the RGB-PC color
space. Otherwise, S DTV is used for SDTV and EDTV sources, and HDTV for all
other sources.
• Component: For SDTV and EDTV resolutions, the RS-440 uses the S DTV color
space. For all other resolutions HDTV is used.
In most cases, the Auto setting determines the correct color space to use. If it does not,
you can force the RS-440 to use a specific color space. Choose one of the following:
• HDTV sets the color space matrix to that defined in ITU-R BT.709.
• S DTV sets the color space matrix to that defined in ITU-R BT.601.
• RGB-PC uses RGB color space and sets black at 0,0,0 RGB and white at
255,255,255 RGB, assuming an 8-bit image.
• RGB-Video uses RGB color space and sets black at 16,16,16 RGB and white at
235,235,235, assuming an 8-bit image, to correspond to the luminance values defined
in digital component standards.
BrilliantColor™: Select BrilliantColor™ from the Picture Adjust menu to enable ( On ) or
disable ( Off ) BrilliantColor processing, which improves brightness in grays and secondary
colors by using the spoke light from the color wheel.
Black Level: Select Black Level from the Picture Adjust menu to compensate for
incoming elevated black levels present in some Composite video and S-Video sources.
(This control does not affect other source types.) Set it to
0 IRE if blacks appear elevated
(dark gray). If blacks appear “crushed” (too dark), set it to 7 IRE .
S ave S etting s : To store changes to picture quality settings for the current input and
resolution in the “Custom” Picture Memory, select Save Settings from the Picture Adjust
menu. To recall this preset at a later time, press the
CU S T button on the remote control or
select “Custom” from the Picture Memory menu (see above).
You should save changes to any of the following settings to a preset; otherwise they will
be lost when a new input source or resolution is selected:
• Aspect ratio (saved per source)
• Picture adjustments (brightness, contrast, color saturation, tint, sharpness, gamma,
color temperature, color space, BrilliantColor™ and Black Level)
• RGB/YUV signal settings (H. Position, V. Position, Clock, Phase)
• Setup menu settings (Sync Threshold, DNR, Film Mode, Lamp Power)
• White Balance settings (gain and offset)
Re s et to Default s : To reset all picture quality settings for the current input and resolution
to their factory-default values, select Reset to Defaults from the Picture Adjust menu.
To store changes to the ISF Night or ISF Day Picture Memory preset,
select Save Settings in the ISF menu (refer to
ISF on page 52). You
must enter a passcode to access the ISF menu.
Note