Runco LightStyle LS-12d, Руководство по установке и эксплуатации

Страница: 67 / 152

Installation
LightStyle™ LS-12d Installation/Operation Manual 51
PRE
L
IMINAR
Y
3.9
Primary Lens
Adjustments: Focus,
Zoom and Position Lens zoom, focus and position are motorized adjustments that are adjustable using the
remote control (Figure 2-7). This allows you to adjust the focus and image size while at the
screen for more accurate results.
To access the motorized lens controls:
1. On the Dimension Digital Controller remote control or front panel, press MENU .
2. Select S ervice from the Main Menu and enter the Service Menu passcode.
3. Select Di s play Device from the Service Menu.
4. Select Configure from the Display Device menu, then select Len s .
The Lens menu controls operate as described below.
Focus To focus the projected image, use the cursor buttons to highlight “In” or “Out.” Then,
press and hold the
ENTER button.
Zoom To make the picture smaller (zoom out), use the cursor buttons to highlight the minus sign
(-). Then, press and hold the
ENTER button.
To enlarge the picture (zoom in), use the cursor buttons to highlight the plus sign (+).
Then, press and hold the
ENTER button.
Vertical and Horizontal
Lens Shift To change the lens position, use the cursor buttons to highlight “Left,” “Right,” “Up” or
“Down” in the Lens menu. Then, press and hold the
ENTER button to shift the lens in that
direction.
To return the lens to its home position (no horizontal or vertical shift), use the cursor
buttons to highlight “Home” in the Lens menu. Then, press the
ENTER button.
3.10
Adjusting the Picture
Orientation By default, the LS-12d is configured for a “floor/front” installation, in which the projector is
installed upright and in front of the screen. If it is installed behind the screen and/or
mounted on a ceiling, you must change the picture orientation. To do this:
1. On the Dimension Digital Controller remote control or front panel, press MENU .
2. Select S ervice from the Main Menu and enter the Service Menu passcode.
3. Select Di s play Device from the Service Menu.
4. Select Configure from the Display Device menu, then select In s tallation .
5. Select Orientation , then choose Floor/Rear, Ceiling/Front or Ceiling/Rear, to match
the installation method.
If you prefer, you can also perform lens adjustments from the
projector using the built-in keypad. For detailed instructions, refer to
KEYPAD on page 7.
You must enter a passcode to access the Service menu.
Note
Note
You must enter a passcode to access the Service menu.
Note