Runco LightStyle LS-12d, Руководство по установке и эксплуатации

Страница: 102 / 152

Operation
86 LightStyle™ LS-12d Installation/Operation Manual
PRE
L
IMINAR
Y
• Di s play 3D S etting s : Select Display 3D Settings from the Display Device - Configure
menu to adjust the following timing settings for the projector’s 3D Sync output (see
Figure 3-21) to optimize performance of the glasses, emitter and projector, for realistic
simulation and 3D images.
• Dark Interval: This control adjusts the amount of dark time between displayed
frames for 3D content. Higher settings provide more time for shutters in the 3D
glasses to open and close, ensuring that each eye sees the full image intended for it.
• S ync Delay: This control adjusts the output 3D emitter delay to match the active
glasses to the left/right frames of the projector. Proper adjustment of this delay will
eliminate crosstalk and odd colors caused by timing differences between the
glasses and the projected image.
• Invert S ync: Some third-party 3D emitters and glasses require an inverted sync
signal to display the left and right fields in the correct order. If this is the case with the
emitter and glasses you are using, check the
Invert S ync box.
• Te s t Pattern Enable: To display the 3D test pattern (refer to Test Video on
page 81) while adjusting these settings, check the Te s t Pattern Enable box.
• Internal 3D S etting s : Select Internal 3D Settings from the Display Device - Configure
menu to adjust the following timing settings for the Dimension Digital Controller’s
3D Sync output (see Figure 2-6).
If you have connected the Active 3D Emitter to the projector as shown in Figure 3-21,
these settings have no effect.
• S ync Delay / Te s t Pattern Enable: Refer to Display 3D Settings , above.
• 24Hz 3D Mode: This control selects how 24Hz 3D content will be processed in an
active 3D system. Lower frame rates can lead to excessive flickering, creating a need
for frame rate conversion (FRC) to 60Hz in each eye (120Hz total). The FRC modes are
as follows:
• 120Hz 6:4 (default) – Perform FRC using a 3:2 cadence for each eye (3 frames
of A followed by 2 frames of B), resulting in 60Hz per eye, or 120Hz total.
• 120Hz 5:5 – Perform FRC using a 3:2 cadence for the left eye (3 frames of A
followed by 2 frames of B) and a 2:3 cadence for the right eye (2 frames of A
followed by 3 frames of B), resulting in 60Hz per eye, or 120Hz total. This mode
is intended to help reduce judder created in the FRC process.
Network: The options in the Network menu allow you to configure the network
communication features.
• IP Configuration: Select IP Configuration from the Network menu to either set the IP
address, subnet mask and default gateway of the Dimension Digital Controller manually
or obtain these settings automatically, from a DHCP (Dynamic Host Configuration
Protocol) server. (Most broadband routers and gateways support DHCP.) You can also
test the network connection from this menu.
• DHCP: To enable the DHCP client in the Dimension Digital Controller, select DHCP
from the IP Configuration menu and set it to On . With this setting, the Dimension
Digital Controller’s IP address, subnet mask and default gateway are assigned by
the local DHCP server.
To manually configure these values, set DHCP to Off .
The IP Address, Subnet Mask and Default Gateway items in the IP
Configuration menu are disabled (grayed out) when DHCP is
enabled.
Note