Runco 3Dimension D-73d Ultra, Руководство по установке и эксплуатации

Страница: 29 / 152

System Overview
D-73d Series Installation/Operation Manual 13
PRE
L
IMINAR
Y
Rear Panel Layout Figure 2-5 shows the rear connector panel on the Primary DHD Controller.
Figure 2-5. Primary DHD Controller Rear Panel
1. MAIN POWER S WITCH
Disconnects or applies power to the DHD Controller.
2. TRIGGER S
Connection for up to three (3), 12-volt trigger-controlled devices such as retractable
screens or screen masks. Output current is limited to 250 milliamperes (mA).
3. U S B
A standard, USB Series “B” connection to a personal computer, for performing
software upgrades and other service procedures.
4. R S -232 (To Acce ss ory Box)
A male, 9-pin D-sub connector for interfacing with the Secondary DHD Controller.
(Use a “null-modem” serial cable for this connection.)
5. Di s play Control
Connect this to the RS-232 input on the left-eye (top) optical engine on the D-73d
projector.
6. IR
Wired input from a Niles- or Xantech-compatible, infrared (IR) repeater system. It is a
3.5-mm, mini phono jack, wired as follows:
Ring = No connection
Tip = IR Input
Sleeve = Ground
7. POWER INPUT (100 to 240 VAC)
Connect the DHD Controller to power here.
8. HD2 Input (5 x Analog BNC s )
Connect the HD 2 input to the Left Analog output on the 3Dimension Processor.
The HD 1 input is not used with the D-73d. Connect your Component/RGBHV
sources to the 3Dimension Processor.
9. Video 1 Input (RCA)
Connect the Video 1 input to the Left Composite video output on the 3Dimension
Processor.
The Video 2 and Video 3 inputs are not used with the D-73d. Connect your
Composite video sources to the 3Dimension Processor.
A B C D E
H
DHD4
Primary
Do not connect any video source directly to this box.
Pr
R
Y
G Pb
B
Pr
R
H V
HD2
T
Video
Video 3 Pr Pb
HDMI 1 HDMI 3
F G
HDMI Out
Audio Only
HDMI Out
To Display
Ethernet
PC / Control
RS232
TRIGGERS
USB RS-232
1 2 3
Display Control
IR
Pr
R
Pr Pb Video 3
G B R
12 8 7
6 2 5 4 3
11 14 13
1
9 10