Runco 3Dimension D-73d Ultra, Руководство по установке и эксплуатации

Страница: 74 / 152

Installation
58 D-73d Series Installation/Operation Manual
PRE
L
IMINAR
Y
1. Remove the two Yaw/X Adjustment Levers and Washers ( 7 ) from the bottom of the
Anamorphic Lens Holder ( 2 ).
2. Place the Anamorphic Lens Holder on top of (or under, if the projector is inverted) the
AutoScope Lens Motor Carriage Plate or CineWide Base Plate. Position the bracket
so that the slots at the bottom of the lens holder are perpendicular to the
corresponding slots on the base plate.
3. Secure the Anamorphic Lens Holder to the plate using the Hex Bolts/Washers ( 6 ) and
Yaw/X Adjustment Levers that you removed in Step 1.
4. Use the 1/4-20 Button-head Screws ( 4 ) to attach the Anamorphic Lenses ( 1 ) to the
Anamorphic Lens Holder. Attach (but do not fully tighten) the 4-40 Set Screws ( 3 ).
Anamorphic Lens
Adjustment
If you are installing a D-73d with anamorphic lenses, proceed as follows to adjust them.
1. Select the Cinema aspect ratio using either the DHD Controller remote control unit
(see Figure 2-8) or the OSD menu (press MENU , then select A s pect Ratio ->
Cinema ). (With a D-73d/CineWide with AutoScope, this should position the
anamorphic lens transport in front of the primary lenses.)
2. On the DHD Controller remote control or front panel, press MENU .
3. Select Calibration from the Main Menu.
4. Select Adju s tment Mode from the Calibration Menu and set it to Primary .
5. Press EXIT (or MENU ) repeatedly to return to the Main Menu.
6. Select S ervice from the Main Menu.
7. Select Te s t Video from the Service Menu and choose Primary Alignment .
Adju s ting the Left (Top) Anamorphic Len s : Align the primary (left-eye) image with the
screen by adjusting the Left (top) anamorphic lens to produce the least amount of
distortion.
• Horizontal Po s ition (X-adju s t): Loosen the Yaw/X-Adjustment Levers underneath
the lens holder. Then, slowly move the anamorphic lens into place so that there are no
shadows on either side of the screen:
When the horizontal position is properly set, tighten the Yaw/X-Adjustment Levers to
secure the lens in place.
To avoid clipping the corners of the image, position the anamorphic
lenses as close as possible to the primary lenses.
Tip
➤
Too Far Right
Too Far Left
Correct position