rulmeca RDR BL3, Техническое руководство

Страница: 34 / 40

TECHNICAL MANUAL FOR THE RDR BL3 - V1.1 DRIVE ROLLER Rev. 21/09/2018 page 34
12 CONVEYOR COMMISSIONING PROCEDURE
-
Check that the rollers of the roller conveyor rotate freely.
- Check that all the fixing screws are tightened correctly and to the correct torque setting
-
Check that cabling complies with specifications.
- Check that function settings are correct.
-
Check that all the connection cables are properly posed in order to avoid short circuits with metal structures.
- Make sure that any movable items (gate or carriages) do not damage cables or electrical parts as they pass.
-
Make sure that all the protection systems are working.
- Before starting up the roller conveyor, make sure that there are no people in hazard areas.
- Make sure that all the moving parts, transmission items are properly guarded (where necessary) or
protected from accidental contact.
- Keep fingers, hair and loose clothing at a safe distance from moving parts.
- Check the roller conveyor for damage suffered during assembly. If a problem is found the head of the work
site must solve the problem BEFORE running the conveyor.
- Make sure the environmental conditions are compatible with the specifications for every single component
of the conveyor.
- Make sure that all metal parts (roller support profiles, rollers, Drive Rollers and any movable parts of the
roller conveyor) are grounded.
-
Make sure that all the emergency pushbuttons are working and are connected correctly.
Only after the check list has been successfully completed, the conveyor can be commissioned.
After a period of monitoring of the operating cycles and the material flow, proceed with logic or mechanical
corrections.
After a certain period, upon completion of the system test, check again that the fixing screws have been tightened
by the correct amount and check the wiring again.
PROCEDURE IN THE EVENT OF ACCIDENTS OR FAULTS
If accidents or faults occur, proceed as follows:
- Press the emergency switches to stop the conveyor IMMEDIATELY.
-
Wait for all the packages in transit on the conveyor to come to a stop before occupying the transit routes.
- In the event of an accident, give first aid and alert the competent authorities, describing the accident as
accurately as possible.
-
Inform the person responsible for machine safety.
- If an emergency state has been started (with power supply units disconnected) and in total safety of all the
other systems operating on the conveyor, remove the cause of the fault.
- When optimum system status has been restored, make sure that no persons are working on the conveyor
and obtain the consent of the person in charge of the roller conveyor to restart the conveyor.