10
2007 RuggedCom Inc. All rights reserved
Rev100
2.2.2 DC Power Supply Wiring and Grounding
Figure 5 - DC Power supply wiring and grounding diagram
The RS910 low voltage DC power supply features reverse polarity protection and dual independent
inputs. The latter feature allows the connection of two DC sources with the same nominal voltage
to provide redundant power supply inputs.
The RS910 DC power supply inputs should be connected as follows:
1.
Connect to the DC inputs according to the polarity markings on the unit.
2.
Surge Ground should be connected to the Chassis Ground via a braided cable or other
appropriate grounding wire. Surge Ground is used as the ground conductor for all surge
and transient suppression circuitry internal to the unit.
3.
Chassis Ground must be connected to the protective earth.
NOTES:
1.
Equipment must be installed according to the applicable country wiring codes.
2.
All line-to-ground transient energy is shunted to the Surge
Ground terminal. In cases
where users require the inputs to be isolated from ground, remove the ground braid
between Surge
and Chassis
Ground. Note that all line-to-ground transient protection
circuitry will be disabled.
