50
Picture 10
-8.2-2
10.8.2
Pendant mount
Picture
10-8.2-1
NOTICE
1. The installation site must be able to support
the sum of weight such as the dome
、
the bracket
and the pedestal four times.
. The chosen wall of installation site must be
solid and have no delaminated phenomenon,
must make sure the bracket installs on the wall
but not in the superficial slipcover.
2
On the installation wall, use pendant bracket as a templet
to mark the center position of the hole (as picture 10-8.2-1)
shows).
User use the electric drill to drill three M6 holes on the
installation surface. The length is around 75mm and then
install M6 screw. (as picture 10-8.2-2 shows)
Wind close one side of the connector
into the
base, then use M4*10 fasten screw to lock the connector.
（
G1-1/2
”
)
Picture
10-8.2-3
Using the 4pcs M6*12 screws to lock the PTZ and the
pendant bracket together
，
then fix them on the wall.As
shown in figure 10-8.2-3
The user must install the outdoor bracket
according to below requirement strictly.
It does not belong to our maintenance
scope if the dome was damaged causing
by disobey the requirement to install.
NOTICE
Installation Introduction
