Ruff Cycles Ruffian, Оригинальное руководство по эксплуатации

Страница: 29 / 40

29
MAINTENANCE
6.6.3. CHANGING TIRES/TUBE
» Unscrew the valve cap from the valve.
»
Release the air completely by pressing the
valve pin halfway the valve.
»
Remove the tire at one side of the wheel rim
with the aid of a tire lever. If required, use a
rinsing agent and water for an easy lifting of
the tire.
» Pull off the tire and tube and perform the required changes.
»
Inflate the inner tube only moderately (diameter approx. 0.78 in (2 cm)) and
relocate it in the tire.
»
Insert the valve into the valve opening of the rim and pull both tire and tube
from one side onto the rim.
»
Observe the direction as indicated by the manufacturer, if available.
» Next, lift the other side of the tire with the tire lever onto the rim.
»
Inflate the tire to maximum pressure as indicated on the rim, in order to
install the tire evenly on the rim.
It is normal when you hear “Plop”.
»
Reduce then the pressure according to the required value (see Chapter 3.1.).
» Screw the valve cap onto the valve.
6.6.4. FRONT WHEEL ASSEMBLY
»
Remove the transportation lock between the
brake pads.
»
Thread the front wheel carefully into the fork.
Make sure that that the brake disc does not to
skid into the brake pads.
» Insert the quick release axle into the fork and
hub and tighten the nut some turns, while you
hold the quick release handle.
»
Flip up the quick release lever, in parallel position to the fork leg. The clamp-
ing force should increase during the locking. If this is not the case, re-open
the quick release and retighten the nut.