Ruff Cycles Ruffian, Оригинальное руководство по эксплуатации, Страница: 14 / 40

14
COMMISSIONING
2.6. ADJUSTING SUPPORT LEVEL
For the adjustment of the support level, press
the „+“ button on the control unit until the
required support level is shown on the display.
To lower it, press the „–“ button.
2.7. SWITCHING ON/OFF THE LAMP
By pressing the light button, the LED head-
lamp and rear light are switched on and off.
Detailed information on the operation of the board computer is
found under 4.1.1. Intuvia board computer.
2.8. INITIAL ENGAGEMENT OF BRAKE DISCS
Your brake system is delivered with a weak break function, because the
surfaces of the brake discs and pads have not been engaged yet. With a new
Pedelec, and also when changing the brake discs and pads, you should en-
gage the brake discs as follows:
»
Accelerate the Pedelec to approx. 15.53 miles/h (25 km/h)
» Brake the Pedelec by both brakes until standstill
(avoid to block the wheels!)
»
Repeat this procedure as often as required in order to achieve an optimal
brake performance.
If you force too much the front wheel brake, a hazard of tipping over
exists. Your rear wheel might lift and have you fall over the handlebar.
-> Pull a little less at the left brake lever, or fully release the brake
lever, when you notice that the rear wheel is lifted.