RTS DEXXO PRO RTS, Руководство пользователя

Страница: 29 / 68

Dexxo Pro RTS
Copyright © 2017 SOMFY ACTIVITES SA. All rights reserved. 4
EN
Operation in «Partial opening» mode with a Keygo type remote
control or similar
Obstacle detection operation
When an obstacle is detected during the open cycle, the door will stop.
When an obstacle is detected during the close cycle, the door will stop and then reopen.
Once an obstacle has been detected, the light will flash for 30 seconds.
Light operation
The light will come on each time the motor drive unit is operated. The light will go out one
minute aer the door stops moving.
Repetitive use will cause the lighting to be lit constantly which may result in the light being
switched off automatically due to thermal protection.
Manual release cord operation
Dexxo Pro is fitted with a manual release mechanism so that you can move the door manually
should a power failure occur, for example. The manual release mechanism should be easily
accessible and located
no more than 1.80 metres above floor level.
[1]. Disengaging the motor drive mechanism
Pull on the manual release cord until the door drive mechanism is disengaged.
[2]. Manually moving the door
This is possible as long as the door drive mechanism is disengaged.
[3]. Reengaging the motor drive mechanism
Move the door manually until the drive mechanism comes to reengage itself into the
transmission rail.
When disengaging the motor drive mechanism, use caution for a badly
balanced door may cause sudden door movement that may be dangerous.
Only use the cord to disengage the motor drive mechanism. Never use the
cord to move the door manually.
Always reengage the motor drive mechanism before sending another
command to the motor drive unit.
4.2 Special operation
Depending on the peripherals installed and the operating options set by your installer, the
motorisation may perform the following special operations:
Operation in «Total opening» mode with a 3-button remote
control
Operation in «Partial opening» mode with a 3-button remote
control
Safety photoelectric cell operation
An obstacle detected between the cells will prevent the door from closing.
The door will stop and then completely or partially reopen (depending on the setup selected
during installation) when an obstacle is detected during the close cycle.
The light will flash for 30 seconds during this process.
Pedestrian door safety function
Opening a pedestrian door within the garage door will prevent the door from moving.
The light will flash for 30 seconds during this process.
Flashing orange light
The orange warning light will flash every time the door moves.
A two second delay before the door starts to move can be selected during installation.