8-
Do not abuse the power cord. Never use the power cord to carry the tools or pull the
plug from an outlet. Keep the power card away from heat, oil, sharp edges, or moving
parts. Replace damaged power cords immediately.
9-
When operating a power tool outside, use an outdoor extension cord marked “W-A” or
“W”.
10-
Stay alert. Watch what you are doing, and use common sense when operating a power
tool. Do not use a power tool while tired or under the influence of druges, alcohol, or
medication.
11-
Dress properly. Do not wear loose clothing or jewelery. Contain long hair. Keep your
hair, clothing and gloves away from moving parts.
12-
Avoid accidental starting. Be sure the trigger is released before plugging in.
13-
Remove adjusting keys or wrenches before plugging the tool in.
14-
Do not overreach. Keep proper footing and blance at all times.
15-
Use safety equipment. Always wear work gloves and the included ANSI approved
safety goggles.
16-
Use clamps (not included) or other practical ways to secure and support the
workpiece to a stable platform.
17-
Do not force the tool. Use the correct tool for your application.
18-
Do not use the power tool if the trigger does not operate properly.
19-
Disconnect the power cord plug from the power source before making any
adjustments, changing accessories, or storing the tool.
20-
Store idle tools out of reach of children and other untrained persons.
21-
Maintain tools with care. Keep tools clean.
22-
Check for misalignment or binding of moving parts, breakage of parts, and any other
condition that may affect the tool’s operation. If damaged, have the tool serviced
before using.
23-
Use only accessories that are recommended by the manufacturer for your model.
24-
Tool service must be performed only by qualified repair personel.
25-
When servicing a tool, use only identical replacement parts.
26-
Avoid unintentional starting.
27-
Do not force the Nailer.
28-
Never leave the Nailer unattended when it is plugged into an electrical outlet.
29-
Do not load staples with the trigger depressed or when plugged into the power socket.
30-
Fire fasteners into an appropriate work surface only.
31-
Do not fire fasteners too close to the edge of a workpiece.
ASSEMBLY AND OPERATING INSTRUCTIONS
Warining
: This nailer is not suited for nailing or stapling into concrete, masonry, bricks, or
metal. So not fire if staples are jammed in the Nose section.
1-
The nailer should not fire if the safety is not depressed against the workpiece.
2-
Turn the ON/OFF switch OFF and make sure the tool is disconnected from the power
supply.
3-
Empty the maganize of nails.
4-
Check that the trigger and the safety of the tool, move freely, without sticking.
5-
Plug the tool into the power outlet.
