6-
Test the tool by depressing the safety of the tool against the workpiece without pulling
the trigger. The tool must not cycle fire. If it cycles, stop immediately and take the tool
to an qualified service technician for repair.
7-
Hold the tool away or off of the workpiece. The safety of the tools should return to its
original position. Squeeze the trigger. The tool should not cycle. If it cycles, stop
immediately and take the tool to an authorized service technician.
8-
Depress the safety of the tool against the workpiece and squeeze the trigger. The tool
must cycle once only. If it fails to cycle or fires more than once, take it to an
authorized service technician.
Loading Brad Nails and Staples –
1-
Depress the lever and extend the inner maganize all the way out.
2-
When loading Brad Nails, make sure you insert the pins of the nails on the side of the
magazine with the groove in it. The Brad Nails should fit into the groove. When
loading staples, insert them crown up, onto the magazine.
3-
Slide the extended inner magazine or you may damage the tool.
OPERATING INSTRUCTIONS
The ON/OFF switch is located at the rear of handle. To turn the tool on, press the top of the
ON/OFF switch to turn the tool off, press the bottom of the ON/OFF switch.
When the unit is loaded with fasteners and you are ready to begin, plug the Nailer Power Cord
into a power outlet.
1-
Hold the tool with both hands, so that the nose is flat against the workpiece, making
sure that the safety is also firmly against the workpiece.
2-
Gently squeeze the trigger to fire the tool.
3-
If you need a deeper driving depth, adjust the depth adjustment knob.
Note: Practice depth adjustment on scrap material first.
4-
If more depth is needed, and you are nailing or stapling into a hard surface, you may
apply pressure on the top of the unit.
Note: Each time you fire the Nailer Gun, the safety must be pressed firmly against the
workpiece.
Removing Jammed Staples
1-
First unplug the Nailer. If a nail is jammed in the discharge area, simply remove it
with pliers.
2-
If a nail is jammed in the magazine, depress the lever and extend the inner magazine
all the way out. Use a flat and or needle nose pliers to free the Brad Nail.
MAINTENANCE
Tool service must be performed only by qualified repair personnel. Service or maintenance
performed by unqualified personnel could result in a risk of injury. Make sure that the tool is
unplugged from its outlet before performing any maintenance. Do not use damaged tools.
Check for loose screws, make sure all screws tight. Make sure the nose is clear of all dirt or
debris. When servicing a tool, use only identical replacement parts. Follow instructions in the
