RTI VHD-8, Инструкция по установке и эксплуатации, Страница: 22 / 32

8x8 HDBT Video Matrix Switch
VHD-8
22
CHAPTER 3 | INSTALLATION AND OPERATION
WEB INTERFACE - NETWORK CONFIGURATION PAGE
Upon logging into the web interface the Network Configuration page will be displayed.
IP ADDRESS CONFIGURATION
IMPORTANT NOTES:
• Setting a static IP address is not necessary. The RTI two-way driver uses the UPNP
name of the VHD-8 to find it on the network.
• Setting a static IP address and clicking “Update Settings” will cause the web interface
to no longer be displayed in your web browser. Enter the new static IP address into
your web browser address bar to access the web interface again.
To set the static IP address:
1. Select Address Type (set to DHCP by default): click this button and select “Static IP”
from the drop down list.
2. Enter Static IP Address : Enter the static IP address.
3. Enter Subnet Mask : Enter the network subnet used by the VHD-8 and RTI XP
processor.
4. Enter Default Gateway: Enter the IP address of the network gateway.
5. Click on the “Update Settings” button to save these settings.
NETWORK IDENTIFICATION
This section allows you to change the name of the device as it shows up on the network
and list of UPNP devices.
1. Unit Name: Enter a new VHD-8 name
2. Click on the “Update Settings” button to save these settings.