RTI RTiDock, Инструкция по установке и эксплуатации

Страница: 19 / 52

19
It’s Under Control
®
INFRARED (IR) CONTROL
Controlling the RTiDock is possible using infrared commands from a remote control,
control system, or industry standard IR repeater system. A complete set of IR codes
is available in the RTI Integration Designer programming software or on the RTI
website (accessible to RTI dealers only).
USING THE IR RECEIVER
The infrared receiver is located on the front right side of the RTiDock and accepts IR
commands from wireless remote controls or from an IR emitter.
• Point a wireless remote control device at the front of the RTiDock.
OR
• Attach an IR emitter of an IR repeater system, directly to the IR receiver window.
RTIDOCK
ARTWORK TEMPLATE
SEPTEMBER 15, 2010
POWER RESET ETHERNET RS-232 IR INPUT COMPONENT VIDEO AUDIO USB
Y PB PR S/PDIF LEFT RIGHT
Control
Processor IR
output port
IR Signal Ground
IR plug
USING DIRECT IR INPUT
The direct infrared input is located on the rear of the RTiDock and accepts IR
commands from a control processor of or from an IR emitter.
• Using a cable with 3.5mm (mono) plugs on both ends, plug one end into the
RTiDock IR input. Connect the opposite end of the cable to an RTI control processor
IR output port or IR repeating system connecting block.
IR Connecting Block
IR Receiver
IR Emitter
CHAPTER 3 | CABLES AND CONTROL