Real Time Automation, Inc.
26
1-800-249-1612
Web Interface Data Point List Configuration
The bottom area of the Web Interface Configuration page allows configuration of 1000 data points in
each direction.
NOTE
: Due to the limited number of internal mappings inside the gateway, though each
direction in the Web Interface may be configured for up to 1000 data points, there is an overall
limit, between the read and write direction, of 1000 data points total.
There are three ways to configure this protocol:
•
Auto-Configure Group by Device (Default)
•
Auto-Configure Group by Data Type
•
Manual Configure
NOTE
: You may go back and forth between modes, but when reverting from Manual Mode to either of
the two Auto-Configure Modes, all changes made in Manual Mode will be discarded.
Web Interface Data Point List Configuration: Filter Options
The dropdowns next to
Filter View By
allow the data points table to be filtered so that only the data
points assigned to a specific group or device are displayed.
•
To remove the applied filter, select
All
from the dropdown.
•
Only one filter can be applied at a time.
