RST Instruments MEMS Tilt Beam, Инструкция по эксплуатации

Страница: 8 / 16

MEMS Tilt Beam Instruction Manual
RST Instruments
5
3.2 S
INGLE
MEMS T
ILT
B
EAM
I
NSTALLATION
Determine the MEMS Tilt Beam installation orientation (i.e. Is the Beam to be
installed on the ceiling, wall, or floor). Refer to Figure 4 and adjust mounting
brackets accordingly.
1. Thread a 10mm nut onto each anchor until they reach the desired position
(ensure the nuts are in plane)
2. Place a Belleville washer over each anchor (see Figure 5)
3. Place a Nylon washer over each anchor
4. Place a Nylon bushing over each anchor
5. Slide the MEMS Tilt Beam onto the Nylon Bushings
6. Place a Nylon Washer over each anchor
7. Place a Belleville washer over each anchor (see Figure 5)
8. Thread a 10mm nut onto each anchor, finger tight, and ensure that the Beam is
horizontal or vertical
9. For a single beam installation, where (2) Belleville washers are used per
anchor, turn the nut 2-3 wrench flats (120

-180

) (see Figure 5)
10. For a double beam installation, where (4) Belleville washers are used per
anchor, turn the nut 4-5 wrench flats (240

-300

) (see Figure 5)
10mm NUT
10mm NUT
10mm BELLEVILLE WASHER
10mm NYLON WASHER
MOUNTING BRACKET
10mm NYLON WASHER
10mm BELLEVILLE WASHER
MEMS TILT BEAM
10mm CONCRETE ANCHOR
DETAIL A
SCALE 1 : 2
A
Figure 5: Single Beam Mounting Details