RSL CG24 Monitor, Руководство пользователя

Страница: 41 / 48

39
SETTINGS AND OPERATION
— Continued
Phase Control
Please refer to our poignant and thought-provoking discussion of phasing at
the beginning of the installation section. Normally, the phase switch will be set to the
0
o
setting. However, some situations call for using the 180
o
setting. The best way to
determine this is with the help of a friend (if you don’t have one, just wait until every-
one finds out what kind of home theater system you just bought!). Play some music
over your system that has a good full range sound including bass content. Have your
friend stay at the back of your Speedwoofer and switch the phase control back and
forth while you listen from your seating position. The proper position of the switch will
yield a smooth transition from the bass to the midrange along with the proper amount
of warmth to the sound. Conversely, the wrong switch position will result in a hole in
the upper bass and a lack of warmth and bass sloppiness in the sound.
Power
The master power switch turns the RSL Speedwoofer amplifier on and off and
overrides all other settings.
Auto/On
In the auto position, the RSL Speedwoofer will immediately turn itself on when
it senses bass frequencies from your A/V receiver or amplifier. It will shut itself off af-
ter 20 minutes of no signal. In the on position, the RSL Speedwoofer
tm
will always
stay on unless the master power switch is turned off.
High Level In and High Level Out
Refer to the Installation section. The High Level In and Out connections are
used as an alternative connection methods where it is not possible for a direct con-
nection from the preamplifier. Using the Low Level connections is preferred.
230V/115V
This is normally set to 115V, which is the voltage in the U.S.A. and in Canada.
Do not remove the cover and switch to 230 volts unless you are outside the U.S., and
absolutely sure the voltage in your area is 230! If you are in a country that uses
230 volts, be sure to set the switch to 230 volts and replace the fuse with one
of proper value before plugging the RSL Speedwoofer into the wall. The re-
quired 115 volt fuse is a T8AL/250 8 amp fuse. The required 230 volt fuse is a
T4AL/250 4 amp fuse. Failing to operate the RSL Speedwoofer at the proper voltage
or with the correct fuse, will blow the fuse and/or cause severe damage to your sub-
woofer amplifier. Sadly, this is not covered under our usually liberal warranty.