22
INSTALLATION— Continued
Connecting The Satellites for 5.1, 7.1, And 7.2 Systems
Listed below is our step-by-step guide for wiring your RSL home theater sys-
tem. For alternative methods or suggestions, please consult the instructions that
came with your receiver or amplifier.
1. Prepare the speaker wire. First, separate the positive and negative strands by
splitting the wire insulation down the middle at least a couple of inches. Now
strip off about a ½ inch of insulation from each individual wire end to expose the
inner copper wire strands. Repeat this process for both ends of each wire. Now,
for each separate wire (positive and negative), twist the exposed copper wire
strands together. This will keep the copper strands neat and allow the wires to
be easily inserted into the speaker’s input terminals.
2. To connect the wires, first loosen the input terminals on the back of your
speakers by rotating the heads counter clockwise. Next, insert the twisted end of
the positive wire into the hole of the positive terminal, and repeat for the negative
wire. (Note; all of our terminals are designed to accommodate bare wire or ba-
nana plugs.) With both wires inserted, tighten both terminals by rotating each
head clockwise until the wires are well secured. Be absolutely certain that there
are no loose wire strands making contact with the wires or terminals of the oppo-
site polarity. This will cause a short that can severely damage your components.
Do not allow strands to cause a short
Properly twist wire to eliminate stray strands
Содержание CG24 Monitor
Страница 2: ......
