32
INSTALLATION— Continued
3. Utilizing a Stereo Receiver or Integrated Amplifier
Must Be Capable of Pre-Amp, Power Amp Separation
This method is a slight variation of sections #1 and #2 above. The only difference
here is that your pre-amplifier and power amplifier are not separate units, they are
both included in your stereo receiver or integrated amplifier. Once the pre-amp and
power amp sections are separated, you will be able resume setup with either method
#1 or #2. For this scenario, you will need four RCA cables, and two speaker cables.
1.First, you will need to disconnect the pre-amp section of your stereo receiver
from the power amp portion. Do this by removing the U-shaped rods that con-
nect the “pre- amp out” to the “power-amp in” jacks. If you can’t find these U-
shaped rods, your receiver or integrated amplifier may use switches to separate
the sections instead of rods. (Consult the receiver’s owners manual for addi-
tional help.)
2. Now, see step 2 of section #1. “Utilizing RSL Speedwoofer
tm
’s Built-in High
Pass Filters”, or step 2 of section #2 “Utilizing High Level Filters With Your
Power Amplifier”(For this scenario, you will need two 100 Hz high pass filters
available separately) and two “Y” adapters.
4. Utilizing The High Level Connections Of The RSL Speedwoofer
tm
10
.
Содержание CG24 Monitor
Страница 2: ......