6.
Install the retaining brackets as shown using the self
tapping screws provided (Picture 10).
7.
Install a set of brackets close to the face of the unit on
the angle portion of the catalyst holder. Make sure that
the holes for the secondary air tube remain open
(Picture 11).
8.
Carefully put the catalytic in place (Picture 12) and hold
in place with the 1/4” screws and washers provided.
9.
Replace the primary air screen and the secondary air
tube.
10. You can now stand up the Opel AP again, then put
back the refractory liners and the doors.
After the facing is installed
1. Attach the control eye to the bypass rod by tightening the
setscrew with a 1/8” Allen wrench (Picture 13).
2. If the bypass rod is too short due to thick brick facing,
attach the extension. Measure the required length from
the threaded end and cut off excess before installing the
control eye.
3. Insert the handle into the control eye.
Page 22
OPEL AP
Figure 18b: Installation of the catalytic kit
4
5
6
7
