RS Automation AnyTouch V606e+, Руководство по эксплуатации

Страница: 8 / 20

8
Battery Replacement Procedure
The following battery is available for replacement.
Name Type Contents
Battery for replacement V7-BT+
• Coin-type lithium primary cell 1
• Caution sticker 1
1. Replace the battery "V7-BT+" within three minutes after the unit is turned off.
If replacement within three minutes seems to be difficult, save a backup copy of the SRAM data using V-SFT Plus (cable:
V6-CP+) before replacing the battery.
2. Turn off the unit. Open the battery holder slowly. The battery in the socket will come into view.
3. Unplug the battery connector, and remove the battery from the socket.
Take out the battery while pressing the center of the battery holder cover as shown in the
figure.
4. Set a new battery. Fit the battery into the socket in such a manner that the red cable side of the battery faces the
battery holder and the cable is oriented downward. Insert the battery in the "a" side first, and push it down to "a" while
inserted in the "b" side.
5. Plug the battery connector and close the battery holder cover.
6. Remove the existing caution sticker.
Enter a date five years from now for "Battery Replacement" on the new caution sticker, and attach it to the backside of
the unit.
7. When the backup copy of the SRAM data has been saved in step 1, turn on the unit and load the data to the unit.
Battery connector
Printed circuit board
Battery holder cover
Socket
"b" side
"a" side