RS Automation AnyTouch V606e+, Руководство по эксплуатации

Страница: 7 / 20

7
E
ng
lis
h
Battery Mounting Procedure
Electric shock hazard. Steps 2 to 5 must be performed while the power is not supplied to the unit.
1. Turn off the unit.
2. Open the battery holder cover.
3. Check that the battery is securely attached to the backside of the cover, and connect the battery connector.
Battery connector
Battery holder cover
4. Close the battery holder cover.
5. Enter a date five years from now for "Battery Replacement" on the sticker on the
battery holder.
6. Check that the battery is correctly connected on the Main Menu screen. When the
battery is not connected, the [SRAM/Clock] switch blinks and the message "Battery not
set" is displayed at the bottom left corner. When the battery is correctly connected, the
[SRAM/Clock] switch goes out and the message is cleared.
When the battery voltage has dropped, the message "Brownout Battery" is displayed.
If the battery voltage drops before five years has elapsed, replace the battery
immediately.
Safety Instructions on Handling the Battery
Lithium batteries contain combustible material such as lithium or organic solvent. Mishandling may cause heat, explosion
or ignition resulting in fire or injury. To prevent accidents, pay attention to the following cautions when handling the lithium
battery.
○
Be sure to discharge static electricity from your body before battery replacement.
○
Use the battery "V7-BT+" for replacement.
○
Rough handling of the battery may cause a fire or chemical burn hazard.
○
Do not disassemble, incinerate or heat the battery.
○
Observe the local and governmental regulations when disposing of waste batteries.
○
Keep batteries out of reach of children (If swallowed, immediately consult a doctor.
）
○
Never re-charge the battery.
○
When the battery leaks or smells, the leaking battery electrolyte may catch a fire. Keep from heat or flame.
Enter a date five years
from now.