20
To
Power Pack
TRACK
Terminals
Attach to
TRACK
Station Stop Hookup Diagram
with no train modifications
(Full Featured YardMaster only)
For a simple station stop, this is all you need to do!
Make sure to program the YardMaster for the desired time delay before adding the jumper.
When the power supply is turned on the YardMaster will switch to RED and the
train should run. When a train enters the isolated section it will be sensed and the
YardMaster will switch to GREEN. The train will stop. After the programmed
time delay the YardMaster will switch to RED and the train will run again.
Change direction of the train as required. The YardMaster will operate in both directions.
Adding a signal light is optional, but adds to the fun.
Station
Stop NO SENSORS
Programming:
* Set time delay as
desired.
* Set lap count as
desired.
RRConcepts.com
1
2
3
4
5
6
20
19
18
17
16
15
7
11
8
12
9
13
14
YardMaster
Power In
Jumper Wire between 1 & 2
Attach to transformer accessories or any 12 to 18 volt
AC or DC power source.
Isolators
on inside rail
Parts List
YardMaster 1
Track Isolators 2
wire as required
Terminal
17
Outside
rail
Inside rail
