19
To
Power Pack
TRACK
Terminals
Attach to
TRACK
anywhere
on loop
Station Stop Hookup Diagram
Place MAGNET
on bottom of engine.
Add additional sensors in PARALLEL
for additional station stops.
For a simple station stop, this is all you need to do!
Make sure to program the YardMaster for the desired time delay.
When the power supply is turned on the train should run. If it does not then press the
Alternate button. This is a one-time operation since the YardMaster will remember the
switch state in memory.
Change direction of the train as required. The YardMaster will operate in both directions.
Terminals 3 & 4 connect to the AC transformer, polarity is not important.
Terminals 5 & 6 connect a “wall wart” DC voltage source. The voltage must be between 6 and
12 volts. Polarity is not important.
Terminals 17 & 18 connect to the track, polarity is not important.
Switch GREEN
Sensor
RED Terminals
AC trains,
Station
Stop using sensors
Programming:
* Set time delay as
desired.
* Set lap count as
desired.
RRConcepts.com
1
2
3
4
5
6
20
19
18
17
16
15
7
11
8
12
9
13
14
