8
Rev. 12.04.2017
9
Rev. 12.04.2017
Installation
Assemble the device in accordance with the illustrations:
1.
Connect panels and strips:
VI MACHINE OPERATION – BASICS
Device control:
Once the device is assembled and connected to the power, the basic colours and light intensity can be
changed and other functions can be selected. Remove the film from the batteries before using the remote
control.
VII TRANSPORTATION AND STORAGE
Shaking, crashing and turning upside down of the device should be prevented when transporting it. Store it
in a properly ventilated place with dry air and without any corrosive gas.
VIII CLEANING AND MAINTENANCE
•
Unplug the device when cleaning it.
•
Use cleaner without corrosive substances to clean surface.
•
After cleaning the device, all parts should dry well before the device is used again.
•
Store the unit in a dry, cool place, free from moisture and direct exposure to sunlight.
•
Never spray the device with water jets.
IX CHECK REGULARLY THE DEVICE
Check regularly whether the device is damaged. If it should be damaged, please stop using it immediately and
contact your customer service to solve the problem.
What to do in case of a problem?
Please contact your customer service and prepare the following information:
•
Invoice number and serial number (the latter is to be found on the technical plate on the device).
•
If relevant, take a picture of the damaged, broken or defective part.
•
It will be easier for your customer service clerk to determine the source of the problem if you give
a detailed and precise description of the matter. The more detailed your information, the better the
customer service will be able to solve your problem rapidly and efficiently!
CAUTION:
Never open the device without the authorization of your customer service. This can lead to
a loss of warranty!
2.
Then carefully cut the tape with the LED segments. Make sure you don‘t cut any of the wires!
3.
Remove the strip which protects the adhesive and stick the illumination elements to the inside of the
device using the adhesive tape on the LED segments. To stick segments to both levels of the fountain,
run the wire through the round opening in the panels. This opening is also used for the fountain power
cable.
4.
Then connect the plug at the end of the illumination strip to the controller. Make sure that both arrow
tips are pointing in the same direction. Then connect the controller to power.
5.
Assemble the fountain base. To do that, insert the larger hexagon between the two larger round panels
and screw everything together (use the included nuts). Then align the smaller hexagon and the smaller
round plate as shown on the picture (the smaller hexagon and the plate are not permanently attached.
The structure will become stable once it is inserted into the chocolate fountain).
Description of each key
Group 1: These buttons, depending on the selected functions, are used to
adjust the brightness of the device (group 2) or to regulate the frequency of
the colour change etc (group 3)
Group 2: The buttons are used to change light colour.
Group 3: The buttons activate a pre-programmed function (automatic
colour changes, etc.).
ON – The button is used to turn the illumination on
OFF – The button is used to turn the illumination off
3
1
2
