
ROXELL - 0318
VITOO -
USER'S GUIDE -
EU
9
PROBLEM
YELLOW
LAMP
CAUSE
CORRECTIVE ACTION
4. Auger kinked .
5. Wheel inside intake boot is
blocked.
6. Obstruction in the tube.
7. Feed in front of the sensor in the
control pan.
8. Too much dust on the sensor in
the control pan.
Replace damaged auger.
Disengage wheel or replace if necessary.
Find blocking spot and remove the obstruc-
tion. SEE NOTE* .
Check if the control pan is empty.
Unmount the control pan and clean the
sensor.
NOTE : IF THE AUGER OF THE CIRCUIT IS BLOCKED AS A RESULT OF ONE
OF THE ABOVE PROBLEMS, IT WILL BE UNDER SPRING TENSION, SO BE EX-
TREMELY CAREFUL AND PROCEED AS DESCRIBED BELOW THIS PAGE*
DANGER
6. The circuit :
- stops
pre-
maturely.
- does
not
stop in time.
a. Time set on time clock is not suffi-
cient.
Adjust time clock programming.
b. The sensor in the control pan is de-
fective or not properly adjusted.
Check the sensor operation and replace if
necessary
7. Auger runs
erratically.
a. When using the system for the first
time.
This is not a breakdown; it will be ok after a
couple of days.
b. Auger too short.
Adjust auger length.
c. Auger kinked as a result of care-
less installation.
Replace kinked parts.
d. Auger coupling not properly in-
stalled.
See installation instructions. Replace coup-
ling if necessary.
e. Circuit too long.
Check maximum length and install an extra
power unit if necessary.
f. Circuit not properly suspended
(loose or ineffective suspension).
Realign circuit. Check all suspensions and
readjust where needed.
* WHEN THE AUGER IS BLOCKED, PROCEED AS FOLLOWS :
1.
Put the main switch in position ”Off”.
2.
Locate the blocking spot precisely.
3.
Reload the motor protection (left or right).
4.
Find the cause and correct. (See page 8 : 3., 4., 5. or 6.).
5.
Put main switch in position ”ON”. The circuit is ready for a new feeding cycle.
.
SWITCH OFF THE MAIN SWITCH OF THE CENTRAL CONTROL
PANEL BEFORE YOU PROCEED WITH MANUAL CHECKS OR RE-
PAIRS OF AUGERS OR POWER UNITS !
DANGER
Содержание Vitoo
Страница 1: ...00803650 00803650 008 0821 VitooTM User Guide EN ENGLISH Original User Guide ...
Страница 17: ......