50mm
50mm
6. Landing ladder and fence
Secure the ladder attachment piece using 2 x 50mm screws to the bearer of the landing floor, 400mm from the back panel. Position the ladder so that its upright framing is
against the bearer of the landing floor and the top step is against the ladder attachment piece. Secure with 2 x 50mm screws, screw through the top step of the ladder into
the ladder attachment piece. Secure the tops of the ladder framing to the fence top rail using 2 x 50mm screws. To the left of the ladder secure three fence railing evenly
spaced using 4 x 35mm screws to the landing floor and fence top rail. Fix seven fence railing in the same way to the right of the ladder. Secure the ladder to the floor using
two L-brackets and 4 x 25mm screws per bracket as shown below.
400mm
50mm
50mm
50mm
35mm
5. Landing floor
Attach the landing support block over the join of the two side panels at the same height as the landing support framing. Secure using 2 x 50mm screws. Place the landing floor
onto its support framing and push up against the side panels. Secure the landing in place using 7 x 50mm screws, screw upwards through the support framing into the bearers
of the floor. Position the fence top rail to the apex frames, ensure the rail is in line with the edge of the landing floor using 1 x 50m screws at each end of the rail
Important
Landing support block must be
positioned the same height as the
landing support framing
Landing support block
Screw up through the
landing support fram-
ing into the landing
bearers
25mm
4. Securing the walls to the floor
Ensure the walls are sitting square on the floor and secure them down using 16 x 50mm screws, screw through the panel framing into the floor.
50mm
Back panel
Side panel
50mm
Important
Fence top rail must be in
line with the edge of the
landing
7. Roof purlins
Insert the five roof purlins into the rebates in the front and rear walls. Fix in place using 1 x 50mm screw at each end of each purlin. Screw through the purlin and into the
frame of the apex panels.
50mm
Drill pilot holes for
each screw in this
section.
Drill pilot holes for
each screw in this
section.
Drill pilot holes for
each screw in this
section.
Drill
Drill pilot holes for all 50mm
and 35mm screws this section.
50mm
50mm
Drill
Drill
50mm
Drill
