1. Laying the floor section
Prepare a level area for the playhouse to sit. Attach three wooden or similar bearers of size 50 x 50 x 1810mm (not supplied in kit) to each floor section.
To "
VALIDATE
" the guarantee, this item should be erected
on 50mm x 50mm treated wooden or similar bearers
(These are not supplied with the kit.)
Ground contact
must be avoided.
Back panel
Side panel
Panel frames
rest on floor.
Panel cladding
overhangs floor
edge.
50mm
Small side
panel
Angled back
panel
2. Fixing the wall panels together
Position the angled back panel and a small side panel on the floor as show. Note how the panel frames sit on the floor with the panel cladding overhanging the floor edge.
Ensure square and secure using 3 x 50mm screws through the frame of the side panel into the frame of the back panel. Position the other back panel next to the first, ensure
level and secure them together using 3 x 50mm screws through the frame of the first back panel into the frame of the second. Continue adding the rest of the panels as
shown in the diagrams.
Small side
panel
Drill pilot
holes for each
screw in this
section.
Drill
Landing support
back panel
Large side
panel
Large side
panel
Small window
Panel
Large window
panel
Use this diagram to check the
correct orientation of the corners
Important
Ensure the back
panel and apex
panel interlock
correctly.
Apex
panel
Back
panel
50mm
Drill
Drill pilot holes for
each screw in this
section.
Ensure the door header
panel and front window
interlock correctly.
header
panel
window
panel
3. Door header, apex panels and door hinge strip
Position the door header panel on top of the small window panel, make sure the bottom shiplap board of the header panel fits correctly into the top shiplap board of the
window panel. Secure to the large window panel using 2 x 50mm screws, then secure it down to the small window panel using 2 x 50mm screws. Lift one apex assembly on
top of the back panel, make sure the bottom shiplap board of the apex panel fits correctly into the top shiplap board of the back panel. Secure by using 2 x 50mm screws,
screw up through the top frame of the back panel into the bottom frame of the apex panel. Attach the second apex panel to the front of the building in the same way. In the
door opening, fit the door hinge strip to the end of the left panel as shown. Drill pilot holes in the strip before securing with 3 x 35mm screws.
35mm
Drill
Drill pilot holes for
each screw in the
hinge strip to avoid
splitting the timber.
50mm
50mm
