Roundup 9210880, Руководство пользователя

Страница: 12 / 28

12 P/N 1011263 Rev. C 12/15
Installing Belts
1. Follow the steps for Removing Belts.
2. Wipe both sides of the new Belts
with a clean, sanitized towel sprayed
with an approved sanitizer and allow
to air dry.
3. Wipe all four rollers and the backing
plate with a clean towel sprayed with
sanitizer. Make sure to remove all
debris from the rollers and backing
plate so they are as clean as possible.
4. Slide the new front belt gently over
the front top roller and front bottom
roller.
NOTE: Make sure the belt lines up prop-
erly on the rollers. The snaps on
the belts should face the inside of
the top front roller.
5. Slide the first crown belt over the
rear top roller and rear bottom roller.
Repeat this step for the club/ heel
belt and the second crown belt.
NOTE: Make sure the belt lines up prop-
erly on the rollers. The snaps on
the belts should face the inside of
the top rear roller.
6. Return the Front and Rear Belt Roll-
ers to full tension by lifting them up
so each roller locks into place (Figure
14).
7. Slowly lift up the Lower Belt Frame
Lock so the Front and Rear Belt
Rollers lock into place (Figure 15).
If necessary, lift up the cam shaft of
the Rear Belt Roller while lifting the
Lower Belt Frame Lock into place.
8. Re-engage the Upper Belt Frame
Lock by lifting up and then locking
it in place on the Front Conveyor As-
sembly (Figure 15).
9. Close and latch the Side Panel.
NOTE: Inform the Store Manager after
any Belt Replacement so new
Belts can be ordered. To obtain
new Belts, contact the factory at
1-877-392-7854 (North America
only) or 630-784-1000.
10. Set the Compression Knob to 4.
11. Re-install the Front and Rear
Conveyor Covers and then the Bun
Feeder. Re-install the optional Top
Cover assembly (if present).
12. Plug in the toaster and test the unit
before returning to service.
TENSE
TENSE
LOOSE
LOOSE
Figure 13. Conveyor Rollers
Figure 14. Conveyor Locks
LOWER BELT FRAME
LOCK
UPPER BELT FRAME
LOCK