Rottler SG7, Руководство по эксплуатации и обслуживанию, Страница: 25 / 102

Section 3 Safety SG7 Manual
www.rottlermfg.com
3-4
No single list of electrical guidelines can be comprehensive for all shop
environments. Operating this machinery may require additional
electrical upgrades specific to your shop environment. It is your responsibility to make sure your electrical
system comply with all local codes and ordinances.
This machine operates under computerized control and, as is all
computerized equipment, and is susceptible to extraneous electrical
impulses internally for externally produced. The machine may make moves out of the operator control at
any time. The operator should work in and around the machine with caution at all times.
The operator and nearby personnel should be familiar with the location and operation of the Emergency
Stop Button.
Make sure all electrical equipment has the proper overload protection. This machine should have a fully
isolated power supply to prevent damage and uncontrolled movement of the machine. If this machine is
on the same power lines that are running to other electrical equipment (grinders, welders, and other AC
motors) electrical noise can be induced into this machines electrical system. Electrical noise can cause
the controller to see false signals to move. Not supplying a fully isolated supply to the machine may void
factory warranty. Refer to the Power supply section located in the Installation section for voltage and
amperage requirements of this machine.
Machine Operator
The operator of this machine should be a skilled machinist craftsman who is well versed in the caution,
care, and knowledge required to safely operate metal cutting tools.
If the operator is not a skilled machinist he/she must pay strict attention to the Operating Instructions
outlined in this manual, and get instruction from a qualified machinist in both production and operation of
this machine.
This machine has the following areas of exposed moving parts that you must train yourself to respect and
stay away from when they are in motion
Cutting Tool Area – Any operation involving hands in the cutter head area, such as inspection or
alignment of the cutter head or tools, changing Centering Fingers, tool insertion, and removal, cutter head
changes, and size checking etc. requires the machine to be in Neutral.