RotoSpa DuoSpa S080, Руководство пользователя

Страница: 6 / 36

6
For complete safety, there are certain guidelines which must be adhered to when installing your
Rotospa hot tub.
To prevent the risk of electric shock, NEVER place any electrical appliance within 2 metres of your
spa.
ALL ELECTRICAL CONNECTIONS MUST BE CARRIED OUT BY A QUALIFIED ELECTRICIAN AND MUST
CONFORM TO BS 7671 REGULATIONS. ELECTRICAL EQUIPMENT WITHIN THE SPA MUST HAVE
EQUIPOTENTIAL BONDING WHICH COMPLIES WITH THE REGULATIONS OUTLINED IN BS 7671
SECTION 544 “PROTECTIVE BONDING CONDUCTORS” AND SECTION 702 “SWIMMING POOLS AND
OTHER BASINS.”
The appliance should be supplied through a residual current device (RCD) having a rated residual
operating current not exceeding 30ma.
The appliance must be permanently connected to fixed-wiring, and a IP rated, weather protected
power supply. Your spa should be powered by its own dedicated circuit incorporating a means for
disconnection in accordance with your local wiring regulations, such as a rotary isolation switch. This
must not be installed any closer than 2 metres, but no further than 3 metres from the spa. Means
for disconnection from the supply mains should have a contact separation in all poles that provide
full disconnection under overvoltage category III conditions.
The appliance contains no serviceable parts, therefore do not attempt service of this control pack;
contact your spa dealer or Rotospa directly if you require assistance. Low voltage or improper wiring
may cause damage to your appliance. Read and follow all wiring instructions when connecting to the
power supply.
Turn the mains power OFF before servicing or modifying any cable connections .
It is not recommended your spa is supplied through an internal switching device such as a timer, or
a circuit that is regularly switched on and off by the utility, as this can create a hazard by inadvertently
resetting the thermal cut-out.
If there is any damage to the supply cable, then it must be replaced by Rotospa, your spa dealer, a
licensed electrician or similarly qualified person in order to avoid a hazard.
To prevent an electric shock hazard and/or water damage to your appliance, all unused sockets of
the SV Mini controller must have a waterproof seal in place. These are supplied and fitted, and must
not be removed.