Rotolight TITAN X2, Руководство пользователя

Страница: 28 / 56

28
Setting up a Rotolight Elinchrom HSS Transmitter
The below setup instructions are based on the HSS transmitter firmware 1.3 and Titan™ firmware V2.0. To check
the firmware version on your HSS transmitter, this is shown on the screen briefly whilst the device turns on. To
check the Titan™ firmware version, go to the about information in the SYS menu.
If your HSS transmitter has a version earlier than 1.3, please visit the Elinchrom website to update manually, which
should only take a few minutes. If you need an update to your Titan™ firmware, please visit www.rotolight/titan-updates
First, turn on your Titan™ then after a few seconds, turn on your Rotolight or Elinchrom HSS Transmitter. If you are
operating from the correct firmware, the transmitter should automatically find the Titan™ and display this on
Screen (if it does not you can press setup ‘Scan’ on the transmitter to force it to search for compatible devices).
(Note : It may detect it as ‘Apollo’ or ‘Titan X1’ / Titan X2) We automatically set the units to default to channel 1,
frequency 1 out of the box.
Ensure that Skyport receiver mode is set to ‘SPED’ on the Titan™. This ensures that Skyport is active and is in HSS
mode. Similarly ensure the Skyport transmitter is in the same “Speed” mode by pressing setup> ELSP mode>
Speed.
Then, on Titan™ Flash menu
check that both FREQ and GRP
are both set to 1, or whatever the
desired channel and group is that
you wish to use. The frequency
setting (channel 1-20) should
be set to the same on both your
Titan™ and the HSS transmitter.
Press the setup button on the
right-hand side of the HSS
transmitter. Scroll using the rotary
wheel to ‘Frequency’, and ensure
it is on the desired frequency –
we recommend defaulting to
channel 1, however if you happen
to encounter interference from
other signals, try changing to a
lesser used frequency, such as
channel 20.
To then adjust the frequency, press the button in the centre of the rotary wheel and scroll to change the number.
Press the centre button to confirm, which also navigates you back to the main setup menu.
For users wishing to operate both Elinchrom and Rotolight units simultaneously using the HSS transmitter, scroll
using the rotary wheel to ‘ELSP mode’, use the centre button to enter the mode and scroll to adjust to
‘Normal’. Press the button in the centre of the rotary wheel centre to confirm. The screen will change to a green
background colour to confirm you are in Normal mode. Ensure you also change this setting on your Titan™ in
the FLASH menu. You may then need to turn off your transmitter and turn back on again for it to re-register the
units on the display. If you are only operating Rotolight units via the HSS transmitter, we recommend using Speed
mode, which will turn the background colour red.
Flash User Presets : There are ten user programmable radio button user presets available to store and recall your
favourite customised Flash settings (presets 31-40). Press and hold to store a setup, tap the button to recall the
preset. Tap the bank button to access presets 36-40.