©Roto VR is a UK Ltd company. Companies House: 9473421. VAT Reg: 241423444.
28 Church Road, Stanmore, Middlesex, HA7 4XR, United Kingdom www.rotovr.com
10
Cables G & H
Cable G
–
This is a blue splitter cable that you will need to use in order to get rumble to
work from the headset to the Roto.
Please see the Headset Setup section (pages 12-13) for information on how to get rumble
working with your headset
Cable H
–
This is a long male to male aux cable, to be used in conjunction with the control
box and cable G in order to get rumble working with the Roto.
Please see the Headset Setup section (pages 12-13) for information on how to get rumble
working with your headset
Cable I & J
Cable I
–
This is a data cable, it looks like a printer cable. It runs from the left-hand side of
the base into a USB port on your PC.
Cable J
–
This is the power cable attached to the block that would have been included in a
small brown box inside box 1. The end of the cable will need to be plugged in to the left of
the switch on the base, and the mains plug will need to be plugged in to the other side of
the block. If you plug this in and switch Roto on, a light on the left-hand side of the base
should switch on.
Cables K
–
M
These are cables that connect the base to your PC. They are set up in different ways,
depending on the headset, so please check the Headset Setup section later on, in case your
headset requires a different set up.
Cable K
–
This is a HDMI cable, that runs from the base to your PC. Please ensure that this is
plugged in to your graphics card, as it will run better through there.
Cable L
–
This is a USB cable that runs from the base to your PC.
Cable M
–
Cable M is a power cable that is only required if you are using the HTC Vive. This
runs from the base into the link box.