Rotex Posidapt Expert, Инструкция по установке, эксплуатации и обслуживанию

Страница: 98 / 131

RTX-IOM-PRODUCT-YY Page 98 of 131
www.rotexautomation.com
This sub-parameter value is used to monitor the upper limit temperature. Set the threshold in
a range from "- 60.0 °C" to "130.0 °C" or "- 76.0 °F" to "266.0 °F".
Low Pressure Monitoring
Applicable for Posidapt
–Super and Ultra
This parameter is used to continuously monitor the minimum value of supply pressure
recorded. The current inlet pressure is recorded by a pressure sensor on the main circuit
board.
The minimum recorded value is displayed in the “Minimum pressure recorded” diagnostics
parameter. The device triggers a fault message if the current value undershoots one of the
three configurable limit thresholds.
Threshold Limit 1
This parameter is used to set the pressure threshold 1. The device triggers a fault message
if the current inlet pressure undershoots threshold 1.
•
Off
This parameter value does not trigger any message or alarm.
•
Custom
This sub-parameter value is used to monitor the lower limit pressure. Set the threshold in a
range from "0.0" to "10.0" bar.
Threshold Limit 2
This parameter is used to set the pressure threshold 2. The device triggers a fault message
if the current inlet pressure undershoots threshold 2.
•
Off
This parameter value does not trigger any message or alarm.
•
Custom
This sub-parameter value is used to monitor the lower limit pressure. Set the threshold in a
range from "0.0" to "10.0" bar.