Rotex Posidapt Expert, Инструкция по установке, эксплуатации и обслуживанию

Страница: 104 / 131

RTX-IOM-PRODUCT-YY Page 104 of 131
www.rotexautomation.com
The threshold 3 fault message is displayed when the limit threshold 3 is exceeded. The value
can be set up to 100000000.
Monitoring number of direction change
Applicable for Posidapt
–Super and Ultra
This parameter is used to continuously monitor the number of changes of direction of the
actuator caused in the dead zone.
The current value is displayed in the “Number of change in direction” diagnostics parameter.
The device triggers a fault message if the current value exceeds one of the three configurable
limit thresholds.
Threshold Limit 1
Use this sub-parameter to set the limit threshold 1.
•
Off
This parameter value does not trigger any message or alarm.
•
Custom
The threshold 1 fault message is displayed when the limit threshold 1 is exceeded. The value
can be set up to 100000000.
Threshold Limit 2
Use this sub-parameter to set the limit threshold 2.
•
Off
This parameter value does not trigger any message or alarm.
•
Custom
The threshold 2 fault message is displayed when the limit threshold 2 is exceeded. The value
can be set up to 100000000.