Rotenso V26V, Инструкция по эксплуатации

Страница: 114 / 156

82
User manual
Room air conditioner - VERSU X
EN
6. NAME AND OPERATION OF THE BUTTON ON THE WIRE CONTROLLER
CLOCK TIMER CANCEL
SWING TEMP TEMP MODE
FAN
3
1
2
5
7
10
4
6
9
8
1. MODE Select Button
2. ON/OFF Button
3. Adjust Button
4. Adjust Button
5. Time Button
6. FAN SPEED Button
7. TIMER Button
8. SWING Button
9. CANCEL Button
10. Infrared remote receiver
1. MODE Select Button
Each time you push the button, a mode is selected in a sequence that goes from AUTO, COOL, DRY, HEAT
and FAN as the following figure indicates:
AUTO COOL DRY HEAT FAN
Note:
HEAT function is invalid for cool only type unit.
2. ON/OFF Button
When in off state, press this button, the indicator is on, the wire controller enter into on state, and send
setting information to in door PCB . When in on state,press this button,the indicator is off,and send
instruction. If timer on or timer off has been set, it cancel this setting then send instruction to stop the
machine.
3. Adjust Button
Press this key to increase the indoor temperature settings, 1 degree to be increased for every once press.
4. Adjust Button
Press this key to decrease the indoor temperature settings, 1 degree to be decreased for every once press.
5. Time Button
Normally, LCD displays the current time of the setting clock (however, LCD would display 12:00 when the
first time power to the wire controller or reset the wire controller). Press this key lasting for 4 seconds, the
clock will flashing at the frequency of 0.5 Sec. by using and to adjust the time, 1 minute to be increased/
decreased for every once press the / . Long pressing the / , it will increase/decrease 4 times/sec, 10
mins/time. Release the key when finish the clock setting, the time will stop flashing automatically.
PART 6. ZATO WIRED CONTROLLER SUPPORT